EN12090 - Determination of Shear Behavior of Thermal Insulation Products
This European Standard specifies the equipment and procedures for determining the shear behavior. It is applicable to thermal insulating products used in building applications.
The tests described in this standard do not determine pure shear behaviour, but measure the effects of applying two opposite parallel forces to the major faces of the test specimen. The application of a force tangentially to the major surface of the test specimen is considered to represent more closely the stresses imposed upon thermal insulation products in many building applications, particularly walls, than other methods of measuring shear performance, e.g. bending tests.
In principle there are two methods of tests, both in a shear mode:
- Single test specimen arrangement
- Double test specimen arrangement
Single test specimen arrangement
The test machine exerts longitudinal shear forces through two parallel plates bonded to a single test specimen. The parallel plates are mounted to tension coupling mounted to the load cell and the base adaptor of the test machine. This flexibility takes care of the effect of specimen varied thickness.
Test specimen size: (L) 250mm (W) 50mm (T) 100mm
Double test specimen arrangement
The test machine exerts longitudinal shear forces through three parallel plates bonded to a double test specimen. The parallel plates shall be rigid, with the outer plates attached to a fixed mounting to the base of the test machine and the central plate to a tension coupling mounted to the load cell of the test machine.
Test specimen size: (L) 200mm (W) 100mm (T) 100mm
We suggest using a tensile testing system of dual-column design together with the appropriate test fixture according to the testing standard.
For this test, we use the specimen protect feature of Bluehill when loading the specimen and fixture into the machine. This is to prevent any overloading of specimen during this process prior to test. We then in the test method drive to a preload to eliminate any slack in the specimen, then at a constant speed of the crosshead of 3mm/min until a failure occurs. it is important to have a high-speed intelligent test data sampling rate of 100 Hz to the PC ensure the capture and record of shear strength and shear modulus.
We recommend using Bluehill test software package to input specimen parameters, set the desired speed control, automatically calculate the desired results and statistics, and finally to product a test report or send to a network database.
We suggest reviewing EN12090 to fully understand the test fixture and results requirements prior to performing any tests.
Bluehill Universal Software is built from the ground-up for touch interaction and an intuitive user experience. Discover simpler and smarter testing with features such as pre-loaded test methods, QuickTest in seconds, enhanced data exporting: and Instron Connect – a new feature that provides a direct communication link to Service. Users of previous versions of software such as Bluehill 2 and Bluehill 3 can easily upgrade to the newest version of Bluehill.
- 4.4 MB
Instron 3400 Series universal testing systems for tensile, compression, bend, and other material property tests.
- 11.6 MB
Instron 6800 Series Universal Testing Systems provide unparalleled accuracy and reliability. Built on a patent-pending Operator Protect system architecture with an all-new Smart-Close Air Kit and Collision Mitigation features, the 6800 Series makes materials testing simpler, smarter, and safer than ever before.
- 3.6 MB