An Ideal Combination for Fatigue Testing of Dental Implants to ISO 14801

The solution is based on an Instron® ElectroPuls E1000 electrodynamic test system. Two different fixtures clamp straight or pre-angled implants. Both versions can either be fastened on the T-slot base plate of the ElectroPuls test system or installed in a temperature controlled fluid bath.

  • Press Releases
  • 11/13/2012
  • 46.5 KB

Instron at Fakuma 2012

Instron at Fakuma 2012: Measurement and Testing Systems for Research, Development and Quality Assurance

  • Press Releases
  • 9/6/2012
  • 122.5 KB

IPMT Uses Three Instron Electrodynamic Testing Systems to Analyse Failure Properties of Polymers

Undergraduate and post-graduate students at the Institute of Polymeric Materials and Testing (ipmt) at Johannes Kepler University (JKU) in Linz in Austria can rely on three Instron electrodynamic testing systems to help them analyse the failure behaviour of polymers.

  • Press Releases
  • 5/4/2012
  • 269.6 KB

Leading-edge Technologies for Materials and Components Testing Consolidated under one Roof

For the first time ever, five members of Illinois Tool Works' (ITW) Test and Measurement Group will be combining forces at Control 2012, jointly presenting their offering under one roof. At the Stand 1522 in Hall 1, professional visitors will find a host of valuable information for testing a wide spectrum of materials and components, from hard to soft and from ductile to brittle.

  • Press Releases
  • 5/3/2012
  • 179.8 KB

Instron Service Recognized for Customer Satisfaction Excellence

Instron Service receives recognition from the Omega Management Group Corp for achieving excellence in customer satisfaction in field service and support during 2011.

  • Press Releases
  • 3/14/2012
  • 100.3 KB

CEAST AlOxide® performs HDT and Vicat Tests at up to 500 °C

The newly developed Instron CEAST AlOxide® thermal tester determines the Vicat softening temperature and HDT heat deflection temperature of plastics at temperatures up to 500 °C, allowing measurements to be conducted even on highly temperature resistant thermoplastics such as PEEK. Unlike conventional instruments, which use silicone oil as heating medium and typically offer maximum temperatures of 300 °C, the Instron CEAST AlOxide uses heat-resistant aluminium oxide powder in a fluid bed. The method is expected to be adopted in the relevant European standards in the near future.

  • Press Releases
  • 8/31/2011
  • 365.2 KB