Fatigue Testing of Computer Keyboards
Every day computer keyboards are used in offices, factories, and homes around the world. One of the biggest challenges faced by keyboard manufacturers is the long-term durability performance of keys that are subject to repetitive loading from typing.
The objective of this dynamic test was to replicate normal finger presses of a key, from lifting off through to spring reaction through to full compression engagement of the key as it bottoms out.
For this test, we used our ElectroPuls™ E1000 test instrument equipped with a low-capacity Dynacell™ and a simple compression platen to perform the test. An off-the-shelf keyboard was selected and mounted to the t-slot table using two support blocks.
With any component test, the load cell must be mounted to be upper moving actuator to provide accurate load measurement. Using the in-built features of the Dynacell load cell, automatic compensation was set up to overcome problems with inertial forces at very low loads.
We manually jogged the actuator to establish the absolute position of the lift-off point, and we balanced the digital encoder. Using the default position gains, a sinusoidal waveform was run at 5 Hz in position control. Tri-Modal control was then implemented to provide outer loop control of the lower load peak of -2.5 N and a positive lift off in encoder control above the key. Position and load profiles where monitored during the test, and the load profile shows the full engagement, a spring-rebound and the lift-off phases.
$name
- Produtos
- 8/3/2015
- 21.7 MB
ElectroPuls® E1000 All-Electric Dynamic Test Instrument
The ElectroPuls® E1000 is a state-of-the-art, all-electric test instrument designed for dynamicand static testing on a wide range of materials and components. It includes Instron® advanceddigital control electronics, DynacellTM load cell, Console software, and the very latest in testingtechnology – hassle-free tuning based on specimen stiffness, electrically operated crossheadlifts, a T-slot table for flexible test set ups, and a host of other user-orientated features. Poweredfrom a single-phase supply it requires no additional utilities for basic machine operation (forexample, pneumatic air, hydraulics, or water).
- Produtos
- 3/3/2017
- 383.1 KB
Dynacell Fatigue Rated Load Cells
The 2527 Series load cells are designed for use with Dynamic Testing Systems; offering exceptional performance with the ability to measure forces as low as 1/250th of the force capacity to an accuracy of 0.5% of reading. Automatic transducer recognition and electrical calibration, makes them easy to use. The load cells can withstand loads up to 150% of their force capacity without damage and 300% without mechanical failure. All Instron load cells are individually temperature-compensated and tested for accuracy and repeatability on calibration apparatus that is traceable to international standards, with a measurement uncertainty that does not exceed one-third of the permissible error of the load cell.
- Produtos
- 8/17/2018
- 0.8 MB