ASTM D6641 - Compressive Properties of Polymer Matrix Composite Materials Using a Combined Loading Compression (CLC) Test Fixture

ASTM D6641

ASTM D6641 is a testing standard that determines the compressive strength and stiffness properties of polymer matrix composite materials using a combined loading compression (CLC) test fixture. This test method is designed to produce compressive property data on polymer matrix - mainly used in the Aerospace industry - for the purposes  of research and development, quality assurance, and structural design and analysis. ASTM D6641 can be used to test unidirectional (0° ply orientation) composites as well as multi-directional composite laminates, fabric composites, chopped fiber composites, and similar materials.

Test Fixture 

A CLC test fixture such as Instron's CP104483 is necessary for performing ASTM D6641 testing. The fixture is placed between two compression platens which initiate the compressive force onto the fixture, which in turn subjects the specimen to a combination of Shear- and End-Loading.


ASTM D6641 test fixture


Materials Testing System

ASTM D6641 is best performed on a high force universal testing system such as Instron's 6800 Series electromechanical systems with Bluehill Universal software. Though most composites can be tested with a 250kN capacity system, labs testing a wider range of materials may benefit from a higher capacity system. An AlignPRO fixture should be used to ensure accurate results. 

ASTM D6641 Test Setup
 6800 Series Universal Testing System
Bluehill Universal Software
2580 Series Load Cell
CP104483 Custom Test Fixture


ASTM D6641 test setup 
Tips and Tricks
  • The specimen may be untabbed (Procedure A) or tabbed (Procedure B), as required. One requirement for a successful test is that the specimen ends do not crush during the test. Untabbed specimens are usually suitable for use with materials of low orthotropy: for example, fabrics, chopped fiber composites, and laminates with a maximum of 50% 0° plies, or equivalent. Materials of higher orthotropy, including unidirectional composites, typically require tabs.
  • The most important results are the compressive strength, the compressive strain and the compressive Poisson’s ratio determined by Chord method. In addition to these calculations, the failure mode of each specimen is documented with the appropriate failure code as described within the standard.
  • For more information, purchase ASTM D6641.
Related Content

6800 Series Premier Testing Systems Brochure

Instron 6800 Series Universal Testing Systems provide unparalleled accuracy and reliability. Built on a patent-pending Operator Protect system architecture with an all-new Smart-Close Air Kit and Collision Mitigation features, the 6800 Series makes materials testing simpler, smarter, and safer than ever before.

Composites Test Fixtures - Compression

Instron offers several fixtures for the compression testing of composites without anti-buckling guide plates. This is often the preferred way of testing composites, as the free unsupported gauge length is more representative of true compression behavior.

Bluehill Universal Brochure

Bluehill Universal Software is built from the ground-up for touch interaction and an intuitive user experience. Discover simpler and smarter testing with features such as pre-loaded test methods, QuickTest in seconds, enhanced data exporting: and Instron Connect – a new feature that provides a direct communication link to Service. Users of previous versions of software such as Bluehill 2 and Bluehill 3 can easily upgrade to the newest version of Bluehill.

AlignPRO Alignment System

Instron's AlignPROTM system is designed to assist machine operators when measuring and adjusting load string alignment.