Solutions by Industry » Electronics » General Purpose Applications » Peel Testing of Photovoltaic (Solar) Cells

Peel Testing of Photovoltaic (Solar) Cells

With a growing global focus on green energy, companies are racing to develop higher-efficiency, lower-cost solar cells for a variety of applications. Manufacturers recognize the need for mechanical testing to evaluate the performance of the thin films and substrates used to make photovoltaic (PV) cells, also known as solar cells.

The International Electrotechnical Commission (IEC), a leading international standards organization, publishes the IEC 61215 series, Terrestrial Photovoltaic (PV) Modules – Design Qualification and Type Approval, which applies to both crystalline silicon and thin-film modules. The series includes mechanical tests of PV modules that simulate external conditions, such as withstanding wind loads equivalent to 130 km/h.

Peel Testing Thin Film Stacks

A 90-degree peel adhesion test on the various layers of thin film, also known as stacks, is recommended to address these challenges. The test confirms the quality of adhesion between layers, and the resulting peel strength provides an estimate of the adhesion needed for a reliable, long-term electrical interconnection between layers.

Instron's 6800 Series and 3400 Series Universal Testing Systems are well suited to 90-degree peel testing applications. Bluehill® Universal Software can be used to set up test methods and analyze results after testing.

The 90-degree peel fixture is designed to minimize friction, so force measurements reflect the film and adhesive under test. Instron also offers a variable angle peel fixture for testing PV modules at angles other than 90 degrees, such as 45-degree or 30-degree peel testing.

IEC 61646
Solar Cells Peel Test Solar Cells Peel Test Solar Cells Peel Test Solar Cells Peel Test Solar Cells Peel Test

Talk to an Instron Expert

Not sure which system or peel fixture fits your photovoltaic testing needs? Tell us about your application and we will help you find the right solution — no guesswork required.

Talk to an Applications Engineer

Tell us about your testing needs, and we'll help you configure the right frame, load cell, grips, and software for your lab. Please complete the form below, and we'll respond within 1-2 business days. For a faster response, call +1-800-473-7838 or +1 781 828 2500 if you are outside of the US.



Please close this window and accept cookies to view and fill out the form.